SMOK Vision ViviNova tank and ProVari .......

[yuRsOtall]

So....one of the few devices I utilize on my mods is a smok Vivi Nova pyrex tank. I have used it on my ego devices, and my silver bullet. I recently made the jump to a ProVari which I absolutely love. Only problem is when the SMOK tank is screwed onto my ProVari, it completely blocks any and all airflow. I cannot get any draw on it unless i loosen it to the point that it is very very loose on the PV and will not stay attached. Does anyone have any suggestions?

 

[pufZeppelin]

maybe try one of these

- Tank Air Flow Controller for 510 by SMOKtech [gv-SMOKtechTANKAirFlowController] - $3.45 : GotVapes.com, E-cigarette Supplies - Atomizers Cartomizers Mods Juice and more

make it a little taller, but then kinda stealthy

 

[Baditude]

It's pricey, but it will solve your problem: The Hippo Provari cap sleeve.

It looks good on the Provari, too!

 

[xanderxman]

I have used genuine Vision Novas on my ProVari for over a year. Never had an issue with the draw. It is REALLY hard to keep up with all the Nova clones but the Vision Novas have performed fine for me. Baditude's suggestion is a good idea, if a bit pricey. But after what you have probably spent smoking cigs, it should be a drop in the bucket over time.

 

[bosun]

I also use a 'genuine' Vivi Nova on my Provari. Very pleased with its performance. Tried a Protank 2. Not pleased. When screwed down enough to be stable, get no air. Took an old credit card and cut a gasket out of it, placed the gasket on the 510 connector. Gives good air but center pin didn't make contact. Disassembled and cleaned out the juice, moved the center pin down, worked for a while then the center pin moved back up causing flooding. I presume the 510 connector on the Protank was pressed too far in. Maybe I'll buy a new Protank base but right now the device is in my garbage/emergency box. But maybe a shim/gasket would work for your Vivi Nova??