Hi all,
Just purchased a nice little box for myself, the XPRO M65 from smok. I went to change out the button, and did so successfully. When I put it all back together and fired, something burnt bad. I quickly removed my battery from fear of it venting, but it was a component on the chipset that shorted. Would anyone be willing to offer some help? I can't seem to find anything about this on any of the forums. It will only display "check atomizer" now, regardless of resistance (I've tested 1.6 down to .3 ohms). Looked around the board and pulled out the fried component, but can't seem to rewire it to function again.
Thanks for the help!
Just purchased a nice little box for myself, the XPRO M65 from smok. I went to change out the button, and did so successfully. When I put it all back together and fired, something burnt bad. I quickly removed my battery from fear of it venting, but it was a component on the chipset that shorted. Would anyone be willing to offer some help? I can't seem to find anything about this on any of the forums. It will only display "check atomizer" now, regardless of resistance (I've tested 1.6 down to .3 ohms). Looked around the board and pulled out the fried component, but can't seem to rewire it to function again.
Thanks for the help!
