Smoktech udct flooding and then leaking!

[Trashcore]

I recently purchased an mvp 2.0 to upgrade from my c twist. Bought a few different tanks, smoktech udct tank, smoktech bottom coil tank, and a protank mini. Primed the carto, filled the tank and vaped for hours. Decided I wanted to switch flavors. So I got a different carto, did the same thing and now it just constantly floods. Did a lot of reading and realize there can be defects in cartos. So this morning I tried to put the carto that was working fine with the juice that wasn't giving me problems. Well guess what. That flooded very shortly as well. The only tank that isn't giving me fits is the protank mini. I am becoming super frustrated. Is it my mvp 2.0? I don't think I am doing anything wrong because my carto tank for my ego c twist works flawlessly. Any help would be appreciated. Maybe I should buy the protank 2 and be done idk!!!

 

[SupplyDaddy]

It is possible that you have have torn one of the tanks o-rings ever so slightly.

 

[Trashcore]

How do you replace one of those?

 

[Fortyniene]

I found that when using my dct tanks with my mvp 2 they flood if the trim ring is on the mvp 2. In other words there is not enough air flow, so you suck harder causing increased pressure and your carto floods. Take the beuty/trim ring off of the MVP and that may cure your problem as it did mine.

 

[Onelow69c10]

What the above poster said. They will also flood I have found with temp changes.

 

[Baditude]

Using a tank tool will protect your o-rings.



Using anything other than pre-punched cartos can also damage o-rings. Hand-punched cartos deform the carto from a round to oval shape, stressing the o-rings when the deformed carto passes through the caps. Same with cartos that are slotted with a Dremel tool, which can create sharp edges that cut the o-rings.