did I miss something or am I just not going to get an answer? lol
So much NEW at Clouds of Vapor!
- Thread starter Bigbuyer
- Start date
- th_trl_thread_readers 0
- Status
Yes they do...Bruce suggested the 2.8, but I like the 2.4 a little better.
Sorry I though you were saying it as a little joke since you quoted true loves video, which has the map on damn near everything
Anyway AG gave you the answer and yes I can confirm it
There is one on an Ego in my profile album.Bruce I bought the xl clears & the syringe kit...while filling for my first time on these I noticed the size of the syringe was a bit big for the holes...I cracked the unit..its not seeming to leak but do I still go ahead & use it if its not leaking...???? I am so new to this....
I just seen it on allot of "mods" not an eGo I just didn't know if the voltage would be enough how is it on yours? lol
Been doing just fine on my t-rex/ego at 2.4
+1 on the 2.4...much better on the Riva too...IMO.
well looks like I'm gonna have to play the waiting game before I get one lol Thanks allot for the info!!
They go fast when he gets them in, get on the e mail list you will know right away
Do you not know your own strength? Ha Those sound a bit fragile! What did you do different when filling the next one?
Did you use the included little tip? If you cracked the ceramic cup you are probably ok. If the side wall then its gone.
Stormi mods in! The Storm Clear in 4 ml and now 1.5 ml! Both are available in 2.4, 2.8 and 3.2 ohm! Get them before they are gone!
And more eGo kits! Only $58.99! With 2 attys, cones and tips!
Check out my eGo section with cases, chargers, mega and much more!
at COV!
Check out my eGo section with cases, chargers, mega and much more!
at COV!
I can see the crack on the side of the plastic tube...oh well guess I have to learn more on the filling technique
I was wondering if there is a way to fix a clearomizer when the clear tube comes off or if I should just make a syringe mod out of it. The CE-2 works well still just the tube came off after cleaning. Thanks for any advice.
Have you tried putting the tube back over the knurled end if it spins I guess you could use a little glue to hold it ,although I would try heating it a little and then re-attaching. Just a side note on the new clearomizer's I always remove from the PV by pinching the tube at the bottom never by holding the tube it self. I also don't over tighten them on the PV. I also would just remove the filler ring to clean and wash it, as I don't see where taking the whole thing apart helps and if you can't get the tube back on tight your kind of dead in the water at that point anyway.
Last edited:
Yeah I think I overtightened it and then the little o-ring at the bottom was not fitting back on the right way so I tossed it but I am being more careful now. If it does it again I will try your suggestions ....thank you by the way.
- Status
Similar threads
- Locked
