So rda on a istick 30

Status
Not open for further replies.

KnowledgekidJag

Full Member
Jul 7, 2015
19
7
33
So I was sick of my kanger tank. I bought my first rda fishbone I built my first coil this morning. Im super excited any suggestions and ideas will help.
 

Attachments

  • IMG_20151029_012823.jpg
    IMG_20151029_012823.jpg
    802.7 KB · Views: 39

Ryedan

ECF Guru
ECF Veteran
Verified Member
Mar 31, 2012
12,869
19,652
Ontario, Canada
So I was sick of my kanger tank. I bought my first rda fishbone I built my first coil this morning. Im super excited any suggestions and ideas will help.

If you like it, then it's right for you :)

Do you have all that cotton in there to close off some of the air flow? The pic is not too clear, are you using a single coil and is the cotton going through the middle of the coil or just touching the underside of it?

I think you have a lot of wire left after passing the wire through the posts. If you do I would trim that off. The outer one is OK but if the middle one touches the deck it will short.
 

Visus

Ultra Member
ECF Veteran
Jun 4, 2013
1,598
851
55
United States
Too much cotton? You want the coil in direct airflow and all sides of the coil exposed to and in the airflow. The bottom feed airholes of the fish will at any watts provide nice clouds if built right but not if you restrict its airflow.. Less is best! Just enough to slurp up the excess in there. Coils placed "Directly on top of airholes" almost touching it and very minimal cotton.. Just enough to fill the bowl deck slurping up drips.. Its weird ya, but it works best.. Fluffed out and minimal lol x3 said.. For some scientific reason the cotton will flow to the biggest mass like a magnet and you want that to be inside the coil not the deck..
 
Status
Not open for further replies.

Users who are viewing this thread