Sources for parts

[malkie13]

Hi all, long time lurker. Been vaping for a few months now, I've learned /loads/ from reading the forums here. Haven't really needed to post before now because I've been able to find answers to pretty much all of my questions until now. I did a search, and I didn't quite find what I was looking for.

I'm planning to build a mechanical box mod. I covet some of the beauties out there like the Steel Punk Slug, but my wife would probably castrate me for dropping that sort of cash on a mod right now.

What I need help with is a good source for parts, specifically, 510 connectors. Pre-wired is a plus, especially if they use properly thick copper wire, and not those piddly little leads a lot of stuff uses.

Thanks in advance for any help, folks.

Joe

 

[Susan~S]

Hello and welcome!

Once you have the required # of posts you can head on over to the Modding Forum.

 

[NealBJr]

I plan on doing the same fairly soon. I found this, and it just arrived today. Seems very well made. You'll have to do some soldiering, but I think it wil have a finished look to it.

 

[oplholik]

Here is a good place for parts.

DIY Parts

 

[malkie13]

I plan on doing the same fairly soon. I found this, and it just arrived today. Seems very well made. You'll have to do some soldiering, but I think it wil have a finished look to it.

I've pondered ordering an inexpensive mod from FT and just cannibalising it for parts, but that's a good find.

Here is a good place for parts.

Thanks for the link!