Sudden Harshness

Status
Not open for further replies.

d.dutton9512

Full Member
Jul 12, 2010
49
0
41
Atlanta
I've been exclusively vaping for almost two weeks but today it's developed a harshness. I swapped attys, refilled the cart, and checked the foam for any burns but I can't find any obvious reason for the harshness. I've also noticed my carts aren't lasting nearly as long with vapour dropping off but when I go to refill they're almost bone dry.

I vape a 410 with blue foam darts and no other mods. I havent changed juice or anything either and the atty I replaced it with isn't a new one so its not primer fluid. Anyone have any ideas?
 
Last edited:

CaptJay

Vaping Master
ECF Veteran
Jan 3, 2010
4,192
115
A Brit, abroad, (USA)
the harshness and the dryness are linked - once my atty gets dry its acrid as all get out so I suppose your question really is are you using more juice than usual or is it leaking out? Could it be that the foam on your dart mod needs replacing? Or have you tried that already? From what youve said above (providing your atty itself is performing the same way as previously) that's the only thing I can think of to look at.
 

fritos1

Super Member
ECF Veteran
Jun 30, 2010
368
2
59
cleveland
Yeah I have Noticed this as well going to try changeing out my cart filler I'm off tomorrow so I guess I will be useing some TB to change them out and see if this helps.

Actually realised I had a brand new cart in my breif case here at work so I put that in and the harshness went away so I have to replace the filler on my other carts to bring them back too life it looks like. Been vapeing on them a few weeks now.
 

undefind

Senior Member
ECF Veteran
Jul 25, 2010
83
2
45
California
i was having probs with flavor and taste recently. i attributed it to the effect of quitting smoking, but i wasnt totally convinced. i boiled my attys in water for about 5 minutes, and used a dosing syringe to dry them out. TH seemed to get better and flavor seemed to get much better as well. i also stopped taking long pulls and it seems as though i no longer need to make a primer puff (using an M402).

you may just need to clean the atty and not take big hits.
 
Status
Not open for further replies.

Users who are viewing this thread