Super ProVari?

[dam718]

Hah...

So I finally got my mesh and wire for the RSST I ordered 3 weeks ago... Long story there

Anyway... I wrapped a 1.3 Ohm coil and got it all oxidized and firing good on my mechanical, and thought I would see how far I can push it on my ProVari...

Much to my surprise, I am able to fire it at 4.5V without errors.

15.58 Watts

At 4.6V it spits out an E2 error which I expected at 4.4V

Now, I don't wanna burn up my board or anything so I'm gonna run it lower just to stay on the safe side of things... I just thought it was interesting that it's firing a notch higher than it's rated limit of 14.5 Watts.

 

[Telly R]

Good job Dam718... That Provari is a steady beast.

 

[tnt56]

Good job Dam718... That Provari is a steady beast.

Agree with this^^^^^^^^^^^^^^^^^^^^. I test most of my rba's, rda's on my Provari's. I've gone as low as .05 ohms at 2.9 volts. It won't fire for long but long enough for me to squeeze my micro coil's. Well done my friend.
With my ZAPS's I try and stay around 1.8 - 2.0 ohms. (not always right on but at least I try). If it's wrong I start over.

 

[Thrasher]

provape has admitted to rating the limit switch a little conservatively for some head room.