SX mini MX class

[figment_oyi]

I have a yihi SX mini MX class and it suddenly stopped reading coil resistance correctly it reads it way lower than actual if at all..Has anyone else experienced this ? If so do you know how to fix the issue ?

 

[Shawn Hoefer]

Have you tried multiple coils. If not, I suggest you do so. It sounds as though you might have a bad coil. If you've already tried multiple coils, check the center pin of the 510 connection to make sure it hasn't been jammed down or collapsed.

 

[figment_oyi]

Have you tried multiple coils. If not, I suggest you do so. It sounds as though you might have a bad coil. If you've already tried multiple coils, check the center pin of the 510 connection to make sure it hasn't been jammed down or collapsed.

I tried this already, but thank you for the advice

 

[RayofLight62]

Try to reload the firmware. It can fix a problem when there is a memory failure.

 

[figment_oyi]

Thanks for everyone’s help ended up sending it back to where I got it was still under warranty..they were out ..but sent me the new SL

 

[Mordacai]

@figment_oyi, that's nice of your seller. You'll probably really like the SL Class, just need Samsung 30T or 40T batteries depending upon your vaping style.

MTL = 40T
DTL = 30T

A few tips for you, to read coil resistance press in the joystick and then press the fire button to lock the setting. Otherwise you'll end up altering the resistance manually if you try to navigate through the menus.

If you use TC or Joules, use them the same as you would Watts. So 30 Watts = use 30 Joules for example.