Ok so I bought a 1/2ml syringe and it takes forever can someone please post a size that is a quick fill?
Egads. You got a 29 to work? I don't have that much patience when filling.
I use 18g needles from the mouth after popping out the cap. Slide the point down along the side of the barrel to minimize disturbance to the wadding.
I use either 3ml or 6ml, depending on how many I'm filling. 18 GA needles have been perfect so far.
I usually pop the top and go in from the mouth end. Insert the needle between the batting and the inside wall of the carto, and slowly pull the needle out while filling. If it starts to flood, just back out the plunger a bit until it's perfect.
I ordered mine online after reading this:
http://www.e-cigarette-forum.com/forum/diy-e-liquid/81110-11-syringes-4-cents-act-now.html
Got 6 3ml syringes, 6 6ml, and 12 18 GA needles for around 28 cents, including free FedEx shipping.
I use 1 1/2' 22g needles with 3ml syringes ($.25@ publix pharmacy) I also have a 10ml that I use if I'm bulk filling. I also fill from the mouth end after pulling the cap (directly into the batting) then finish it off with a Taryn spin, rinse, repeat (don't actually rinse)
I find that 27g is incredibly difficult to depress and 17g is really hard to control. 22g is a good compromise.

My syringe needles are color coded. The grey ones are too narrow, the blue are too large, the yellow are just right.![]()
Actually, I got them in China.![]()
