T2 Coil Head Replacement

[moped.greg]

So when I first bought All my hardware I got an ego twist, I understand the benefit being able to change the voltage and get a really good vape. I also bout some Kanger T2 and T3 Clearomizers and I love the T2’s a lot. The thing I am trying to figure out is the difference between the different replacement coil heads.
You can get:
1.8-2.2 ohms
2.4-2.6 ohms
2.7-2.9 ohms
3.0-3.2 ohms
I know this may seem like pretty simple questions. I am just not grasping the difference and I want to learn all I can to really enjoy vaping. More than I already do.

 

[Renzuli]

Welcome to ECF . The 1.8 - 2.2 are considered the low resistance heads , the 2.4 to 2.6 , the standard resistance , the one's above that are mostly high resistance . On your twist , you can use the low , standard , and maybe even some of the higher resistance , if you jack the voltage up . Best to use is the LR. and/or the SR one's . Some people like the HR one's at higher voltages , like 6 volts . Your twist , I think , only goes to 4.8 . Hope that helps .

 

[moped.greg]

So basically the lower the voltage you use, the lower the resistance you need. My ego does go 4.8 but i dont crank it that high or it taste really bad. I typically stay in the 3.6-4.2 range depending on juice.