Tank constantly overlfows

[Chicago Dave]

I bought a new tank with two 10mL bottles and by the time I got to the second bottle the tank just keeps overflowing/gargling. Today hoping for the best, I picked it back up after a few days, only topped off the tank and within a few draws it starts gargling and a lot of the juice just seemed to be sucked into the carto. I've already blown out all of the juice a few times and it solved the problem momentarily.

Funny, when I got this tank I had problems getting the juice to get inside the carto.

 

[tj99959]

Air flow at the connector or coil. If the air flow is restricted, the vacuum you create when you draw on it will pull to much juice into the carto and into the center tube.
Provided that the carto isn't to clogged, you can run a wire up through the center tube to restore the air flow. Also on some PV's it's possible for the tank to sit to low and reduce air flow to the connector. Air simply must be able to get to the connector and through the center tube.

 

[Spazmelda]

It could be an air leak in the tank. Not having an air tight seal on the tank will cause gurgling and leaking. I just had one that was doing this ((I make my own out of syringes). No amount of blowing it out or changing the cartomizers would help. I made new seals (gaskets) and it works perfectly again.

 

[Xaiver]

Or you could be drawing too hard on it and forcing the liquid from the tank into the carto. I've pretty much come to the conclusion that once a carto is flooded, it's done. They're designed to be disposable anyhow, pop in a new one and give that a shot.