Tank'd Cartomizer: Burnt Taste, Lack of Wicking

[FlaverSaver]

So I've got a liquinator from Vaporescence with a steel dual coil cartomizer in it. I get a consistently burnt taste and dry draws. I shake it, refill it and change the cartomizer with only temporary relief. Has anyone else had a similar experience? If so, have you found a solution?
Thanks for the help, I would really appreciate any suggestions.


Note: Cartomizer is a Dual Coil Mega with one slot cut into it, not punched.Running on 6v.

 

[tyleris12]

Try adding a second slot or hole, so it can wick better maybe? Most of the ones I use I put two holes in them. Haven't had much luck with the dual coils in the tanks tho, Boges work much better.

 

[RoKeM]

I've used this same set up and had that issue. In my case it was using up liquid faster then it could wick into the carto through the slot. I was able to get around it by taking a couple of quick strong pulls off of it without firing up the PV. This will pull liquid into the slot a little faster and it seems to work well for me. I have also noticed that the thinner liquids work a hell of a lot better on the liquinator.

 

[FlaverSaver]

Thanks guys. Yea, I've tried taking a couple strong pulls without firing the battery. But constantly doing that increases the instances of leaking out of the bottom of the cartomizer. And sadly, I had a cartomizer with a hole cut too big, so it started leaking. Sooo it seems I may be out of options. I'm thinking of going back to dripping, my tank endeavors have been disappointing :\.. Money wise and juice wise. Any other suggestions would be appreciated. But thanks Tyleris and RoKeM for your ideas.


PS. RoKeM, what setup is that? Is that a Silver Bullet? What's the voltage?