Tesla terminator not powering On

Status
Not open for further replies.

Shadowfart

Full Member
Nov 10, 2016
19
28
Welcome to ECF Vanz!

It could either be a faulty mod or the battety is dead/damaged since the indicator isn't lighting up.

Have you tried changing batteries? Is there a +/- indicator anywhere on the mod or in the battery chamber? If that's the case, make sure you don't mix those up, it could be the protection kicking in if you put the battery in the wrong way.
 
  • Agree
Reactions: stols001

lupinehorror

bròn
Supporting Member
ECF Veteran
Verified Member
Jul 11, 2017
3,265
22,602
Dunblane
i once put the cells in the wrong way round in my smok alien. it obviously didn't fire but when i replaced them orientated correctly it still wouldn't fire. i interested them incorrectly tried to fire then replaced them the right way round and it fired just fine. just an experience i had...may not work for you.
also make sure the contacts are clean.
best of luck.
 

stols001

Moved On
ECF Veteran
May 30, 2017
29,338
108,119
I agree it's either the mod or the batteries. If you have other batteries, try them. If not, perhaps travel to a vape shop near you if they have decent employees, they might be able to help you isolate the problem. If it's under warranty, do that sooner rather than later so you can warranty your mod if need be. It sounded like a brand new setup, is it? Or is this something that just started happening? It could be user error, I wouldn't rule that out at this point, but could equally be something else.

Good luck!

Anna
 
  • Like
Reactions: Shadowfart

BrotherBob

ECF Guru
ECF Veteran
Dec 24, 2014
14,118
12,449
Sunnyvale,CA,USA
HI! Im a newbie here, got question about my tesla terminator not powering On, i already tried to charge for 4 hours and it doesn't have a light on the led indicator, not sure if its on the batt or mod itself, any help or comments will be gladly appreciate it.
Welcome and glad you joined.
Not powering on could be caused by several problems.
I would contact:
Local B&M Vape Shop (Visit) -----Might be simple.
Vendor who sold it ---see if they will repair or replace or advise (any authorized distributor).
Manufacturer contact ---see if they will repair or replace or advise.
re: The ECF Troubleshooting Guide - Revision 3
 
  • Useful
Reactions: stols001
Status
Not open for further replies.

Users who are viewing this thread