Maybe you need to:
a) Check minimum resistance of your Regulated mod
b) look at the coil and see if any part is touching metal except the leg ends
c) confirm it reads open/999 with no coil
I had the same issue when i got the tank.i wicked it 3 times but its still the same.it took me 1hr to figure out what went wrong.for me its cos i didnt screw the rba section properly.the glass constraints me from screwing my rba to the connector which connects to the mod.sorry i dont know whats that called.
I had the same issue when i got the tank.i wicked it 3 times but its still the same.it took me 1hr to figure out what went wrong.for me its cos i didnt screw the rba section properly.the glass constraints me from screwing my rba to the connector which connects to the mod.sorry i dont know whats that called.
The Base and you should soak the assembly in Hot water to remove the Glass section so you can properly work around the Base. A lot of them are stuck to the silicone seal, but they should come loose.
Had a similar issue on mine, found out the center post(air tube) of the RBA was not making contact with the center post/contact plate of the base. I just had to pull it out a tiny bit and it started working
I have the tfv4 on the way in the vape mail -- Can't wait to try out those awesome looking coils. I also want to do some fancy building on the rba deck. -- I hope the tank is as awesome as all the review vids I have watched look like it is.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.