"the Killer" atty - anyone have more info?

[anavidfan]

Darn, out of stock. There is another place but also out of stock. I will be haunting these sites. I want at least 2. How long does your Killer last before having to clean it or dry burn or rebuild? How easy is it for you do rebuild, saw a video and seemed easy, but the people doing the video have had a lot of time to practice.

 

[urquidezj]

still havent received it

 

[urquidezj]

It's at the post office. Got back I to town yesterday and I had a notice. Will start a new thread later today

 

[Dnerve]

It looks like it might have a hard time keeping a good ground if you open it in a tank to allow juice to flow. The Ody V1 with locking nut would sometimes lose ground when opening the juice control. The V2 grounded a different way but not sure it's better. I've had trouble and success with both versions. I've noticed on quite a few attys the negative connection is the tricky one and this looks to be the same to me. I'm anxious to see how they sort it out.

True, It happen to me with the first ceramic/coil I replaced (not with the pre-installed one). I was struggling a bit to position the ground wire and some resistance prevented me to tighten it well enough (although there was no gap and it seemed closed, it wasn't tight enough to hold resistance when opening the feed.

The trick is to correctly stick the ground wire in the correct position under the lower/last thread. Although in Greek, a nice video showing the setup can be viewed below:

.

Edit:Whoops, did not notice I was resurrecting an old thread...still some might find this usefull if not elsewhere already.