Theorem Bottom Feed!!! (With Tutorial)

[RevPang]

Hey all,

Just want to share this with everyone.

I use to squonk back in the day (2011) with the Reo mini and the Vapage VMOD. Just recently, I purchased the Kanger Dripbox 160, but the rda that it came with is junk.

While waiting for mail order BF rda, I thought the Theorem would be the best BF rda for me. I have a habit of forgetting to squonk and get burned hits often.

So, I took out the contact screw and notice that the shaft had a ton of space in there and the idea struck me.

20 minutes later I had a bottom feed Theorem.

Below is how i did it.

1. After disassembling the RDA, I drilled a 1/16th inch hole in the shaft under the fill hole. (Only on one side)

2. Then I filed down the contact screw flush to the post.

3. Using a utility knife, I cut the bushing for the contact screw to match the width I filed down.

4. Assembled the RDA after deburring and cleaning. The hardest part of this project was aligning the bushing with the contact screw.

Squonking in action!!!

Enjoy!!!

-Revpang

 

[Btsmokincat]

Nice job! I did something similar with a Tobh RDA. I'll have to keep this in mind if I want to convert my Theorem.

Sent from my SM-G930R4 using Tapatalk

 

[ThaFuzz]

Hey @Btsmokincat , got any pics of your tobh bf conversion? ive got an old one sitting around id like to take a crack at after reading this.

 

[Btsmokincat]

Hey @Btsmokincat , got any pics of your tobh bf conversion? ive got an old one sitting around id like to take a crack at after reading this.

I don't have any pics from when I did it but it's similar to what you did with the theorem. There are two separate insulators, I cut a notch in both and lined them up. Here are pics of the top and bottom of my TOBH clone...

Hopefully you can see the notches I cut.

Sent from my SM-G930R4 using Tapatalk

 

[ThaFuzz]

I don't have any pics from when I did it but it's similar to what you did with the theorem. There are two separate insulators, I cut a notch in both and lined them up. Here are pics of the top and bottom of my TOBH clone...

Hopefully you can see the notches I cut.

Sent from my SM-G930R4 using Tapatalk

I can see the notches, looks pretty easy. That might be next......

 

[ThaFuzz]

Hey @Btsmokincat thanks for the tip. I bfed my tobh last night now i just gotta rebuild it.....

 

[Btsmokincat]

I picked up a couple of Theorems on sale for $6.99 at 101vape.com. So I finally decided to modify my original Theorem for bottom feeding just like you did RevPang...

Sent from my SM-G930R4 using Tapatalk