Tiafun GT on an MVP

[irishnoise]

Will a tiafun GT work on an MVP 2 or does it have to be on used on a mechanical mod?

 

[k2zs]

I would think anything can work IF the overall resistance of the device is over , lets say, the 1.4 ohm barrier. Will it work well? It could if you use a thinner gauge wire in your build and the build is once again higher than the MVP's lower limit.

IMO, if you were to build a 1.4 ohm coil using 30ga wire it will probably work quite well for you...

 

[zeroclue]

Its a little big for it but will work fine, I had to loosen the screw a bit to make connection but good to go

 

[joesquid]

I use a KFL+ on my MVP. Not sure why a Taifun would be any different.

 

[Asbestos4004]

1.4 ohm barrier? A taifun will work just fine on an MVP. 7-8 wraps of .28ga will get you between 1-1.2 ohms. Not too tight on the cotton and you're in business. It won't be the best looking thing in the world but it'll work great.

 

[Completely Average]

It will work, but it's not great. I normally vape at a minimum of 11 watts with my RTAs, and that's the maximum output of the MVP2.

 

[popwarhomie]

11 watts at 1.2ohm with my MVP and Kayfun.