Tips on getting the cap back on tube?

[brodymcd]

I've had to remove my cap on a few occasions to clean it and always have a devil of a time putting it back on. I'm sure it needs to be tight for leak prevention, but is there a secret ninja trick to getting it back on easier? Thanks!

Sent from my SPH-D700 using Tapatalk

Sent from my SPH-D700 using Tapatalk

 

[dopeh]

Put a little juice on the tube, that should lube it up for ya.

 

[DaDoc]

Put a little juice on the tube, that should lube it up for ya.

thanks mate seems to work better ( i felt like trying it out sence i have the same problem every now n then )



vape On

 

[mlinky]

Hold the tube steady and gently twist the cap on.

 

[pack21]

I cut diagonally across the end of the tube, so goes better.

 

[Mudflap]

A little twist to get the tip of the tube thru, then I grab it with tweezers and pull it far enough I can grab it with my fingers.

 

[brodymcd]

Thanks for the tips, guys! Diagonal cut TOTALLY did the trick!

 

[pack21]

Thanks for the tips, guys! Diagonal cut TOTALLY did the trick!

I'm glad I could help.

REOville Rules!

 

[mlinky]

LOL, that's funny. Never even thought of that. All of my feed tubes are already cut on the diagonal.

 

[Big Hitter]

LOL, that's funny. Never even thought of that. All of my feed tubes are already cut on the diagonal.

It helps prevent the "no squonk suction" when it hits the bottom of the bottle too.

 

[pack21]

Deleted, sorry.

 

[jay930]

It helps prevent the "no squonk suction" when it hits the bottom of the bottle too.

Thanks I never thought of this