RDA Trying for 1.0 Ohm

[OnMyWay311]

Hey all,

Ive got some 24 gauge kanthal, trying to achieve a 1 ohm dual coil build on my twisted messes rda. Any suggestion on diameter and number of wraps would be appreciated.

 

[daveid777]

That would be 22 wraps on a 3mm bit, I don't think you meant for that. Use Steam Engine to calculate. Even if you meant 1ohm per coil, and 0.5 net resistance, that's 11 wraps. And it'll take a lot of power and time to fire it up.

 

[OnMyWay311]

That would be 22 wraps on a 3mm bit, I don't think you meant for that. Use Steam Engine to calculate. Even if you meant 1ohm per coil, and 0.5 net resistance, that's 11 wraps. And it'll take a lot of power and time to fire it up.

Would the solution be smaller wire, or could I achieve it with larger diameter?

 

[puffon]

Smaller wire would be better for 1 ohm.
May as well learn to use Steam Engine, if your going to wrap coils:
Coil wrapping

 

[OnMyWay311]

Thanks to both of you. In the future I'll use this tool first to cut down on questions I can now figure out on my own.