Tugboat v1 single coil?

[ThugginMcMuffin]

Hi i was wondering about if it would be safe to run a .3 ohm 24AWG nichrome coil (6 wraps) on a Tugboat? also if needed, how would I plug up the other air hole? kinda new to this stuff (not vapes or mech mods, but coil building). Also these are prebuilt coils that I bought and im giving them a try before i start building my own. Thanks for the help!

(also dont know if links are allowed)
here are the coils: New 3 Ohm 50pk Rebuildable Atomizer Coils 24AWG RBA RDA Premade Coil Sub Ohm | eBay

 

[CloudOFsmoke]

I dont know much about nichrome but .33 is just fine.

 

[ThugginMcMuffin]

I dont know much about nichrome but .33 is just fine.

cool thanks for the info. hope everything goes well. my Tugboat gets here at the end of the month.

 

[CloudOFsmoke]

Right on. Puff away!

 

[CG138]

On the tug boat unless you like a really tight draw I wouldn't bother plugging the other side.

 

[ThugginMcMuffin]

On the tug boat unless you like a really tight draw I wouldn't bother plugging the other side.

I was told on that the v1 tugboat, since the airholes are non ajustable, that if you ran single coil than you had to plug up one side since it would be SUPER airy. can you confirm this?

 

[CG138]

I was told on that the v1 tugboat, since the airholes are non ajustable, that if you ran single coil than you had to plug up one side since it would be SUPER airy. can you confirm this?

To me it has a tight draw without plugging a hole. I don't think you will have problem leaving both open. If you think you need to plug one use a vape band and tilt it so it only covers one of them.

 

[ThugginMcMuffin]

To me it has a tight draw without plugging a hole. I don't think you will have problem leaving both open. If you think you need to plug one use a vape band and tilt it so it only covers one of them.

thanks for the info and great idea about the band!