Turbo Cartos

[tiraggi]

Hi Ben.
The last batch of Turbo Cartos seem to have a problem. When I fill them, the liquid does not seem to absorb into the poly-fill as before. I get about 10 -15 good hits then it vapes dry. I also have to blow the excess juice before attaching it to the battery or it snorkels and I get a mouth full of juice. I have tried 4 so far from different packs. Anyone else experiencing this? This is the first time it has happened with these turbo's, as they used to perform flawlessly. Maybe the poly is too tight on this batch?

Thanks, Tommy

 

[SnowDragon]

.............................

 

[syntaxevasion]

Hi Tommy,
Have you tried the plunger method, putting liquid in the rubber cap and pushing the cartomizer down into it?

Another way I like to do it is hold it and flick it like a thermometer to force the liquid to the bottom (centrifugal force)..seems to really allow a lot more to go down.

Ben

 

[tiraggi]

Hi Ben.
Yes I usually use the plunger method with the cap.I also tried dripping into the carto with the same results. I did trry another (#5) and it works perfectly. I dont see any difference when I looked inside the poly fill - the others just wont wick the same.

Tommy

 

[syntaxevasion]

Will give you a free pack on your next order, just send a note before you put it in and I'll make sure it gets out to ya

Ben

 

[tiraggi]

Thanks Ben.