I took a look at the guide, but it doesn't really say specifically. Can I buy an o-ring that'll replace one of the ones on the atty connector stalk from Home Depot? Mine tore.
UFS O-ring help?
- Thread starter ChaosAffect
- Start date
- th_trl_thread_readers 0
- Status
Looks like they are 9mm id by 1.5 cross section I don't know if home depot has them but my local ace hardware does
How many do you have, 1 or 2?
Imeo suggested using 1 instead of 2 when the UFS v1 was first introduced. He stated that 2 was not necessary.
Imeo suggested using 1 instead of 2 when the UFS v1 was first introduced. He stated that 2 was not necessary.
As Poppa says Chaos, you may find that using only one works well for you. AS you may have seen on some of the videos like the one Mergryphon made in particular, she only uses one.
I prefer 2 myself for no other reason than being OCD!
But I must admit that using only 1 makes the juice control adjustment much easier with less resistence. 
I prefer 2 myself for no other reason than being OCD!
But I must admit that using only 1 makes the juice control adjustment much easier with less resistence. 
Chaos,
There are a couple of places where the o-ring can be identified. In the Illustration it is listed as #8
(UFS Connector Exploded View)
OR
it is also listed in the o-ring thread under UFS http://www.e-cigarette-forum.com/forum/gg/196089-iatty-ggts-ufs-avs-afs-o-rings-guide.html
The o-ring is a 9mm x 1.5mm
There are a couple of places where the o-ring can be identified. In the Illustration it is listed as #8
(UFS Connector Exploded View)
OR
it is also listed in the o-ring thread under UFS http://www.e-cigarette-forum.com/forum/gg/196089-iatty-ggts-ufs-avs-afs-o-rings-guide.html
The o-ring is a 9mm x 1.5mm
Hmm... It had gotten really leaky yesterday, and I kinda assumed that was because of the missing o-ring. If that's not the case, though, I'll probably just leave it as is. It's the Top o-ring that you should leave in place, correct?
- Status
