:unsure: Primer nastiness

[Dartster]

What's the fastest way to get rid of primer in an atty? This is truly offensive!

 

[mlinky]

Take the atty off. Put a napkin on the open end, and your lips on the battery end, and blow. Keep blowing until nothing more comes out. Put a few drops of juice on the bridge, and vape.

And it IS NASTY. I vaped it once *shudder*

 

[elationisfacile]

Yeah, I just got my first atomizer with primer in it. I tried blowing it out in a napkin but with those first few sets of drops, I'd always get nasty throat burn at the end.... I need a better solution.

 

[dormouse]

Hopefully you have juice. Even after doing the above, it may still taste bad. And I recommend if an empty dummy cart came on your atomizer, use that instead of tainting a stuffing-filled cart with primer taste. if it still tastes bad then mostly vape that off without inhaling. Then blow out again, primer again, vape off without inhaling but check if it tastes better, etc. Until it tastes fine.

And note - the bit of white under your atty bridge belongs there. It's not a piece of napkin or a piece of stuffing. It's a wick that brings juice from cart to atty coil.

 

[cyberwolf]

Adding a few drops of juice or straight PG if you have some and then repeating the blowing process will get even more primer out. I agree on the nastiness, though. I have stuck with only Joye atties for a long time now and they always have primer. I was pleasantly surprised by an EM atty recently that didn't and tasted great from the start.

 

[cowfodder]

Iso wash then full dry will get rid of primer, but then you have to wait.

From my EVO to your eyeballs!

 

[bigtimeweb]

I blow it out, add straight VG or pg, blow that out and repeat once more. Then vape without inhaling till i can tell its almost getting to burnt taste then drip on atty, load it up and go.

 

[meems]

I soak them in alcohol & dry prior to using now, I avoid cracking a new one open as long as I can..they are awful!

 

[10mmshooter]

I blow them out. Then add some juice. The draw on them a couple of times withou inhaling. Add more juice and GO!

 

[Sgt.Taz]

I use my compressor- but in a pinch a can of compressed air works great. Then I do a couple of primer burn offs then add the juice. That stuff is awful and as mentioned make sure it's out before you get it on any of the filling or it'll be stuck in there for awhile.