Ordered this from electronic-cigz.com on 11/24. Received it 12/03. Works great with my EVO. Only place I have ever seen one for a 401 type e-cig.
USB Pass through that works with EVO
- Thread starter rtbob
- Start date
- th_trl_thread_readers 0
- Status
The charger that came with the EVO kit that plugs into the wall and has a USB plug on the other end says the out put is 5.0v 1000ma. Shouldn't this be enough power to run my ecig? The thing lights up when I inhale, but no vapor. If I cut the USB plug end off the pass through and splice in a power supply of the proper voltage/amps will this than allow me to use my EVO with out a USB port? Any info greatly appreciated.
I'm using an Absolutely e-cigs m401 passthrough along with the intellicig mains usb adaptor with no problems. Does your mains adaptor charge your batteries OK? If so then either the passthrough or the atomiser is fkd.
Thank you for the input. How ever the Intellicig charger that plugs into the wall outlet charges my batteries just fine. Using the same atty and pass through I get good vapor when plugged into my lap top. When I plug the Pass through into the USB output on the Intelicig charger, again with the same atty it blinks like it does when plugged into the lap top, light goes on when I inhale, no vapor! Our chargers our prob. diff. due to you being in Scotland. Thanks again.
The thing lights up when I inhale, but no vapor
Strangely enough I am having the same problem with my passthrough this morning after weeks without a problem. It's working approximately 20% of the time but other times I puff I get no vapour and the atomiser doesn't seem to heat but the passthrough led stays lit for around 4 seconds after I stop puffing.
- Status
Similar threads
