Vamo proplem

[The Batman]

When I put my carto tank on my vamo I'm getting almost a kind of burnt taste and when I put it on my EGO twist it's fine. The carto is a 2.8 ohm and I'm at 4.4V on both my Vamo and my EGO. I'm not getting any weird tastes on the Vamo with any of my clero's or attys. Anyone have any idea why this might happen?

 

[SupplyDaddy]

Change to RMS Mode (NO2)

 

[HOPS]

First suggestion, make sure you are in NO2. If you already are, just adjust your volts down to taste. Could just simply be the Vamo is doing a better job at regulating the voltage than the ego was and therefore is giving you a more accurate, albeit hotter, 4.4v.

 

[msween00]

Do you have it in RMS mode rather than the default AVG? (No2 vs No1, respectively). AVG can fire at higher voltages and maybe that's messing with your carto?

Sent from my phone, please excuse typos.

 

[The Batman]

It's in NO2. It seems to be working fine now, not sure why. Been having all kinds of trouble with vaping today, from getting a burnt taste in my evod because the juice is too think and now this. Thanks everyone

 

[myxomatosis]

Are you using a dual coil carto?

 

[The Batman]

Are you using a dual coil carto?

Nope, standard Boge carto

 

[The Batman]

Might have been a battery issue, battery in the vamo died and when I put in a fresh one there was no more burnt taste.

 

[dominus2nd]

like others said, change to no2 mode and try vaping around 8 watts. That should be close to your sweet spot. As far as burnt carto, maybe you didnt prime it fully? if you did indeed burn the carto, its done for. you cannot clean it or salvage it.

 

[zWarlock]

Might try turning down the volts .. Regardless of what the different devices I have "say" they're putting out there seems to be a difference in what they're actually putting out .. Swapping the same tank from my vamo to my provari yields different tastes / results when using the same volts.

 

[Tmartin63]

Just got my new vamo last week. Did exactly what everyone on here suggested and set it up on NO2 mode. Started at 6 watts on a Kanger T3 2.0 ohms, Boba Bounty 24mg, but it tasted burnt, peppery taste and throat hit. Moved it down till that stopped (about 3.5 watts), but then got no vapor. I could definitely tell it wasn't enough power. Put that same T3 on my ego twist set at 3.8, worked flawlessly. Awesome taste, vapor and throat hit. Set the vamo in NO1 mode, set at 3.8 volts and the same thing happened, bad taste, peppery taste and TH. started lowering voltage till I got to 3.0 volts and its perfect. Is it possible the vamo is out of calibration and its producing more power than the setting of 3.0? Tried and get the same results on different juices and T3's. Any ideas?

 

[TampaToker69]

I have a similar problem. Using vivi nova 2.4ohms n02 setting, anything above 4w is burnt. Ohms calculator setting tastes burnt.

 

[Tmartin63]

That's where I started my vamo settings, based on the ohms table. Just strange that the lowest setting is best. After all the posts on VW I couldn't wait to try watts for an awesome vape. Although set at 3.0 this thing rocks