Vaping Coil Winding Jig Tool for Rebuildable Atomizers

[bubbalou32]

Back of days of smokies, I was fumble-fingered when it came to rolling my own. I haven't the patience or dexterity to rebuild coils but I came across this product which may be of some help to those like myself:

https://www.fasttech.com/products/1/10010053/1882306-vaping-coil-winding-jig-tool-for-rebuildable

If anyone has tried one of these, please post your results.

 

[Frenchfry1942]

A friend had one. I just use a drill bit from my tool box.

 

[lulu836]

Almost anything can be used to wind a coil on. Depends on what mm you want. There are machine screws, coat hangers (2mm), toothpicks (round), drill bits, etc.

 

[bubbalou32]

Easier to manipulate than a drill bit for $3:

https://www.fasttech.com/products/1926001

 

[mightymen]

I use syringe needles 1.5 and 2.0 mm, no reason to buy another gadget when I have something useful in my DYI toolbox already.

The jig looks pretty but no advantage over the syringe needles I use now.

 

[twgbonehead]

This one is easier:

Amazon.com: Artistic Wire Coiling Gizmo(R) Deluxe Winder for Jewelry Making

I have both. The one you mentioned does have a 510-tapped hole, so it doubles as a mounting stand while you rebuild your atty.

ETA: Actually I have this one which is $1 cheaper:
https://www.fasttech.com/products/3023/10010053/1878301-vaping-coil-winding-jig-tool-for-rebuildable

 

[BuddyG]

I made this tool and how to make on the vid. Not like other jigs. RDA RTA Coil Tool & How to Make It Using Polymorph - YouTube Let me know what you think. In the vid I make single 2.5mm coil a Parallel coil and a Nano coil on a syringe all with my tool.

 

[ReigntheGamer]

This one is easier:

Amazon.com: Artistic Wire Coiling Gizmo(R) Deluxe Winder for Jewelry Making

I have both. The one you mentioned does have a 510-tapped hole, so it doubles as a mounting stand while you rebuild your atty.

ETA: Actually I have this one which is $1 cheaper:
https://www.fasttech.com/products/3023/10010053/1878301-vaping-coil-winding-jig-tool-for-rebuildable

I have the one from the link at Amazon, though I actually got it from Michael's craft store and I am liking it a lot. My coils always came out slightly off when done on a drill bit, so then there was the whole heat and squeeze stuff to go through.

 

[KeepItSimpleStupid]

I bought one from the local vape shop and it's TINY!!!!, like fit on a elementary school kid's hand tiny, not easy to get leverage with to pull the strong tight, but it does work and I still use mine, it can fit in the little top right pocket of jeans if you needed it to, so thats it best selling point for me, ive thought about figuring out a way to mount it to my table to somewhere I wouldnt have to hold it in my hand while wrapping the coils, then i could get some good leverage on it and get good tension on the wire while wrapping it but havent tried to figure it out yet