VaporChase Review: The Innokin U-Can
- Thread starter Mindfield
- Start date
- th_trl_thread_readers 0
- Status
A glass window would have been awesome, agree. The needle is only about 1/3", so pretty short. Not long enough to fill clearos with recessed seals unfortunately, but good enough for clearos with open reservoirs, tanks with fill holes at the rim, or eGo-T type tanks so you don't have to take the cap off the tank.
That would probably depend on the location of the fill hole and the type of RBA. Genny RBAs, probably because either the terminal posts and/or mesh wick would probably be in the way. RBA tanks may, again depending on the location of the fill hole.
Or maybe make a version with either a tip extension fitting for friction-fit needle tips or Luer-lock type of thing so you can tack on a longer needle when required.
I got mine yesterday, it leaks, leaks bad... Press the button and it comes out the sides where the can threads into the dropper part. Lay it on its side and it just oozes juice... Very disappointed.
That definitely sounds like a defective one. Neither of mine leak in the slightest. I'd have a talk with the vendor and see if you can't get it exchanged, or at least to have him send out a replacement.
I ordered another one from a different vendor and asked them to open it and test it before they mail it... We shall see... Meanwhile I'm waiting for the original vendor to answer my ticket... Been 2 days...
Well, hope the original vendor responds. It's poor customer service not to even acknowledge you, which is a shame. I'm sure the new one will work properly.
They responded with "I'll have to check into it" ehhh... Thanks for the information on these, love ur reviews btw, you are an asset to the community.
- Status
Similar threads
- Locked
- Locked
