Veritas RDA and Tesla invader ii

[thecatholicdad]

Hey all. Ive got a problem with my Veritas on my first box mod (Tesla Invader 2). The Veritas sits flush and makes good contact but the base is not oriented in the most beneficial direction to take advantage of the rda design. Is there a way to adjust this?

 

[Ablonz]

I am assuming it is for laying it down on its side? I don't own either but by looking at the picture that is what you are going for.... Im not sure but the only thing I can think is to (DO NOT ATTEMPT UNTIL CLARIFIED by mod makers or someone who has done it) turn the connector plate on the mod.

 

[thecatholicdad]

I am assuming it is for laying it down on its side? I don't own either but by looking at the picture that is what you are going for.... Im not sure but the only thing I can think is to (DO NOT ATTEMPT UNTIL CLARIFIED by mod makers or someone who has done it) turn the connector plate on the mod.

Thanks Ablonz for the response. Thats what I was thinking too. I'm just not sure if it's designed to do that... Really I'm not even thinking about putting it down on its side... I guess I might be too much of a form factor purist. Just seems to me that center air hole should point up when vaping....

 

[InTheShade]

You could try a silicone / rubber washer or O ring under the atomizer. I use them on a REO to orientate the air hole correctly on the atty.

This is one I use, but they also sell different sizes so you can get it right.

Not sure why it wouldn't work with your setup / atty combo, but it might not.

http://www.reosmods.com/index.php?p...category_id=32&option=com_virtuemart&Itemid=3