Vision Spinner 2 Problem

[Warkiller2009]

I am having troubles with my Vision Spinner 2. This happened yesterday, I was using it (on my plume veil) and I decided to see if it could run on dual coils. So I put the coils on and everything was swell. I hold the fire button and it was like the button got stuck both of the coils got super red for about 7 seconds and the base of the plume veil got hot to the touch. So I immediately took off the plume veil (it was a struggle since it was hot though). I tried to fire it without any tank/rda on it and it would blink blue once and then white 3 times. So, I figured it would be a good idea to charge it. When I put it on the charger it flashed white a few times, but the light telling you when it is done charging stayed green even after I put it on. (Red light = charging Green light = done charging) I cleaned the connectors several times changed outlets and everything. It still was green like if it was fully charged (but it wasn't because I was using it all day). I let it charge for 5 hours or so and took it off. I held the button and it flashed blue once and white 3 times. When I put a tank/rda on it it just flashes once blue and 3 times white. Please help thank you!

 

[Susan~S]

What was the ohm of your build on the Plume Veil?

 

[Jomoke]

Don't know if this is the issue, BUT this is what I found with the Spinner - once it goes through the first cycle of charging, if you take it off the charger and put it back on, it will finish charging. I charge mine when the light on the Spinner is blue - I put it on the charger and after about 20 minutes to a half hour, I take it off the charger and put it back on and it will charge for another hour or so until it's fully charged again.

Hope that helps.

 

[Jspike21]

Why are you using an RDA on a Vision Spinner? lol.

 

[Warkiller2009]

What was the ohm of your build on the Plume Veil?

I believe it was around 0.5 ohms (I know it was a stupid thing to do.

Don't know if this is the issue, BUT this is what I found with the Spinner - once it goes through the first cycle of charging, if you take it off the charger and put it back on, it will finish charging. I charge mine when the light on the Spinner is blue - I put it on the charger and after about 20 minutes to a half hour, I take it off the charger and put it back on and it will charge for another hour or so until it's fully charged again.

Hope that helps.

I will be sure to try that, thanks for the input.

 

[Dusty_D]

Not a Simple Solutions type post. Moving to New Members.

 

[Rickajho]

I believe it was around 0.5 ohms (I know it was a stupid thing to do.

Well, yeah it was. If you want to sub ohm get a PV that can handle it. eGo type batteries have low drain ICR batteries in there that aren't made to be used with anything below 1.8 ohms. They have a protection circuit in there designed to prevent exactly what you were trying to do with it. The protection circuit popped open - the battery is now useless.

 

[Johnny Hughes]

Lucky lucky surpassed the amp limit on that battery by a bit lol