vision spinner II

[tattonj]

I've had my vision spinner 2 for about a month now and haven't had any problems with it until now. I almost always run it on 3.3 volts but this time when I went to use it, it just flashed orange 15 times and then shut off, I tried charging it but when it's on the charger it shows up as a solid orange color and then flashes 15 times if I take it off and try to use it. Anyone know what could be wrong with it? (PS, I'm running a 0.8 ohm coil and using a kangertech tank)

 

[CigmundFreud]

How long have you charged it before trying to use it again. The color when it's charging shows roughly the remaining battery life. It starts at orange, then goes to blue, then to white, then it will just turn off the light when its fully charged. I'd say if yours doesn't change color from orange to blue within an hour of charging, then something's wrong with either your battery or your charger.

 

[klynnn]

Raise the resistance of your coil.

 

[djsvapour]

You put a 0.8ohm coil on a Spinner II?

... ? ...

I can't see how that would work.

 

[Susan~S]

Hello and welcome to the forum. Glad to have you here!

The Vision Spinner 2 has a 2.5A limit.

A 0.8ohm coil is way too low to be run on that battery. Even at 3.3v a 0.8ohm coil is drawing 4.125 amps. That may be part of your problem. I'm surprised your battery has not vented.

 

[DavidOck]

At that low a resistance, the protection circuit has kicked in to keep your battery from venting - sort of a slow motion explosion.

Don't know if it's resettable, but try the 5 click off, then back on. If it's not resettable, then it's time to replace....