Vision Spinner problem. Black wire disconnected, do not know where to reconnect.

[Ahem]

Ok, so I just bought this thing from a store but am now out of state, or I'd take it back. I took the spinner apart when the problem began, and the black wire has disconnected. It is attached to the board in a little circle that says "G". Then, the other end is loose. Not sure where to reconnect this loose end. Anybody know?

Also, is there a way to fix this without solder? I am in an area without stores.

Thanks

 

[SirSteve]

You might try the ego sub forum, all things ego there. eGo Type Models

Sorry about your Spinner, mine has taken numerous falls onto the driveway and the only casualty so far has been a glass carto tank, the Spinner doesn't even have a scratch.