Vision Spinner problems

Status
Not open for further replies.

miketreeguy

Senior Member
ECF Veteran
Verified Member
Jan 15, 2013
96
40
kansas city
Hi,

Complete noob here, any help will be appreciated.

I just received a vision spinner 1300mah today. When I plug it in the charger the power button blinks white approximately 8 times, pauses then repeats. The light on the charger goes from green, to red, to off in about 2 seconds then repeats.

Does it have an internal short or am I completely ignorant?

Thanks in advance,

Mike
 

miketreeguy

Senior Member
ECF Veteran
Verified Member
Jan 15, 2013
96
40
kansas city
Sounds odd, all I can tell you is they come 90% charged so my advice is to use it for awhile then try charging it again, if it does the same thing send it back for a replacement.
Your were right
regarding it already being charged and it is definitely working. I will have to see what happens when it is time for a charge.

Thanks
 

lulu836

Jambalya, crawfish pie, 'da filé gumbo
ECF Veteran
Verified Member
May 1, 2011
1,731
8,377
Shreveport
When it needs a charge the fire button flashes 3 times after each attempt to take a drag. How the Spinner flashes when attached to the charger depends on how badly it needs charging. As the charge progresses the fire button stops flashing or glowing and goes out. You are left with the charger light which should still be red. The charger is constantly checking with the Li-on battery for the state of the charge which is why it goes from green to red to green etc. When full charge is reached the green light on the charger comes on and stays on.

The best bet for a long overall life for the battery is don't let the charge run out completely. They have a life cycle of about 300 full charges (from dead blinking to full charge). If you intervene and keep it charged on a regular basis (like after using it for more than say 12 hours) it will have a long and happy life.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread