Vision V2 Structural issue found

Status
Not open for further replies.

SpringzVz

Senior Member
ECF Veteran
Verified Member
Jul 3, 2012
279
108
Colorado Springz, CO
Ok so after about a month and a half with my Vision V2's I have noticed a structural fail developing. The bottom (opposite the tip) metal band has devloped a gap between it and the plastic clearo body. This is after normal use and no overtightenting. I first noticed that the stem inside no longer was "centered" in the unit and juice was not flowing down the sides as fluidly as before. Then peering more I noticed the stem resting to one side and not sealing completely. When I vaped it the draw was gurgly and left vapor in the clearo. The seal was not flush. I then noticed i could with little effort I could move the stem center again by moving the clearo body. Well if I can move it by hand that meant its loose. I noticed the gap in the bottom ring to plastic joint. Not enough to leak just enough to show that the clearo is no longer solid. I removed it from my twist and laid it flat on my desk with no tip on it and decided to bang it back down tight and flush. With a post it note block 5 inches thick i tapped it a couple times and it reseated. I am putting an expected life of the Vision V2 body (not coil head) at 2 months due to this. I am still happy with that myself but may be an issue for you. vape ON!!!!:vapor:
IMAG0036.jpg
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread