Jeeez, I'm dumb as a box of rocks. I took my VN apart to clean it and had all the pieces parts layed out on a paper towel to dry. After reassembling the darn thing, I had a white silicone seal left over which I'm "positive" belongs to the VN but I haven't a clue where it goes. This seal is about 1/4" long; 7/32" OD; 1/8" ID; square cut on one end and slightly tapered on the other. I could definitely use some expert advice on where this seal belongs. TIA
Vivi Nova Mystery Part
- Thread starter Trainguy059
- Start date
- th_trl_thread_readers 0
- Status
If its white and you took it fully apart, that's the insulating gasket for pos and neg posts from your coil. You need that part. It would have gone on the bottom section of the "head".....
Sent from my {920} using Board Express
Sent from my {920} using Board Express
No no no, it's the "egg" inside the drip tip, put it back in the bottom of the drip tip.
Thanks Doom. I was beginning to think I was doomed over something so simple. I had a hunch that's where it belonged and am assuming the tapered end should point towards the coil seal?
hmmmm...... pointed up i would assume.... i had one in another driptip.... now i remember i came with my nova. i dont think its going to cause the universe to stop if you dont have it, just supposed to help keep the juice in and the condensation and whatnots.
I see what you did there!
Whichever way it doesn't fall out again.
- Status
Similar threads
