Vivi Nova V-Core 2.0

[Adina]

I bought this from fasttech and I'm trying to find out if it is in fact dual coil or not. I keep getting different answers online so I figured I'd ask here.
$6.88 Vivi Nova V-core 2.0 Dual Coil Mods Double Layer Electronic Cigarette Atomizer for Ego - 2.8ohm at FastTech - Worldwide Free Shipping
The product title says "Vivi Nova V-core 2.0 Dual Coil mods Double Layer Electronic Cigarette Atomizer for Ego" with the stated ohm of "2.8".
If it is dual coil then what voltage should I put it at? Like which range would be best for this specific one? I have a chart that I use for single coils but I know that doesn't apply to this.
Also I'm using a vision spinner 1300 mah.
Any help would be greatly appreciated.

 

[wonner]

Start at 4.0 volts and adjust up until you like it. I would expect to end up about 4.8 volts.

 

[InTheShade]

Well I suppose it depends. If it says 2.8ohms, based on experience, it could meter anywhere from 2.3 to 3.2 ohms as manufacturers are notoriously inaccurate when labeling coils.

But I think your question is more of a general one about dual coils and using vaping charts. So without throwing numbers at you, you should be able to use your vaping chart with no problems.

If in any doubt just turn your spinner all the way down and start there, then turn it up until it tastes good to you. In fact, throw that chart away and just do that for every coil head / juice you use. That chart is OK to get a ballpark, but I find different juices often need me to tweak the voltage of my battery - sometimes ending up in the 'burnt' section of some of those charts.

It's all about the flavor, and you will not hurt anything twisting that spinner up or down to find a vape that you prefer - even if that means vaping higher or lower than the chart recommends.

 

[Glenn_K]

Greetings; I can't make out from the pix shown by the above link, but there are dual coil replacement heads available for regular Vivi Novas, as in: [URL="https://www.canvape.com/Dual-Coil-Vivi-Nova-Coils-p/vividualcoil.htm"[/URL]

When I used these dual coils with an eGo Twist, I think I went with just over 4 volts, but that's just personal preference.

Regards
Glenn