VV for thin and thick juices

[Rhals]

For those using VV devices, is there any rule of thumb regarding the thickness of the juice the where you set your voltage? I generally keep my Provari around 4.2 using 3 ohm atty, but I could use some direction for experimenting higher and lower as it pertains to juice thickness - if there are any such guidelines. Thanks - Rhals

 

[tj99959]

What you screw on top of your provari has more to do with the thickness of your juice than what voltage you set it at.
That said every juice will react to voltage a bit differently, and there is no set rule as to where it will be the best because no one else has your set of taste buds.

 

[Ratchet]

Totally depends on the juice. I have 75/25 juices that are better at high voltage and some that taste better at low voltage. You just have to find your "sweet spot" by toying with the voltage. Same for 60/40, 50/50, or even 100 PG juices. Not every flavor is best at the same voltage.... I use a lavatube and adjust voltage depending on juice flavor.

 

[Rhals]

Thanks for the replies - I had a feeling it was more about personal taste, so I will continue to just play around a bit. Being new to VV, I found I really like the versatility so I'm eager to find out how I can get the most out of it. Thanks again - Rhals