vv mod parts

[delchrys]

Hello all,
My name is Bert and i'm from The Netherlands. 30years old and now about 1 months vaping with an EGO-T, with type-a atty and tank system.
I'm looking for info about VV vaping, because i like to be in control
A lot of the electric components used around this forum in the VV boxes, are very difficult to get hands on in Holland. So i'm looking for alternatives or more common parts found in other electric circuit boards.
Still nothing found, what i can use, BTW maybe in computer parts???
But i came up with something, i found an desktop power supply i use for charging batteries. It's output voltage can be regulated with an pot resistor from 4-12V but it's output current is stuck at 2amps.
Can i make use of this power supply to test VV vaping, without breaking my atties?????

Hope someone can help me.

Greetz Bert

 

[Rocketman]

Have you thought about the battery powered drill?
Some of the 9 volt drills run at more than 2 amps.

Check out your local WindMillDepot (HomeDepot here)

 

[delchrys]

found some lm339, ts820-800 and us1150 chips, any good???

 

[delchrys]

i like to make an vv mod based on parts that i can harvest from other dead PCB's, kind of recycling
I like to build a prototype first before i buy parts and make a proper one.
So my harvest parts do not need to be pretty only functional.

like to try VV vaping first before spending money on it, i also want to make my own rebuildable atty, i have like 500metres fibreglass wire laying around and about 1km kanthal wire.

It's like try before I buy....

 

[delchrys]

No-one reused parts before???
Really like to know where i can find parts, i'm not that into electricity, but i can solder and i've made some parts before. But which part i should get or which i can use, i dunno............

 

[TomCatt]

I don't know about the items you listed, but you can get LM2596 modules on eBay very cheaply and work great for VV.


Sent from my iPod touch using Tapa-tapa-tapa-tapatalk

 

[carlton]

You'll probably have better luck looking around in the modding sub-forum. Just a guess on my part as I'm not a modder.

 

[delchrys]

i'm going to look further for the right parts. it's hard to get hands on in holland, but i'll keep trying.

 

[delchrys]

was hoping to find enough useable parts in a computer PSU