what determines flow/ draw rate?

[sit.happens]

With my ego, It seems I have to suck harder than you would with an analog cig. It seems more restrictive in terms of draw.

When everyone speaks about "low-Rez" attys, is the rez or resistance meant by how much effort is required to draw the vap?

I guess my question is, How can I increase my flow rate?

 

[OgreLokon]

Resistance in this sense has to do with the battery power, not the airflow.

And it sounds a bit like your atty is clogged.

 

[clark8876]

The LR refers to the electrical resistance of the atty. A standard 510 is approx 2.4ohm , a LR510 can be as low as 1.5ohms. Be careful if you are going to use LR attys with your eGo, I blame them for killing 7 of my batteries a couple of months ago.

The draw should be long and "unstrained" which is different to drawing on an analogue but sometimes you can have a bad atty that can be hard to draw on. Try another and see if it's the same. Also try using the eGo without the cone and see if that improves things.

 

[UntamedRose]

On the ego...You can actually control the flow with the cone, loosen up the cone a little bit that should increase the air flow. Or you can rock the eGo without the cone all together if you prefer it that way.

 

[enree]

The draw should be smoother than analog. It seems that you need to experiment a bit. LR atty can be seen as if you are vaping through a regular with higher voltage.

I suggest that you vape alternately through two or three attys. Drag in softly for a longer period. Make sure there is enough juice.

 

[BlackMetalBuick]

Definitely give it a try without the cone if you haven't yet. This makes drawing a lot easier on my Inferno (ego clone).

 

[sit.happens]

Ya, I loosen up the cone, big difference! Now Im getting some flow!
Not sure which model I have, but the cone and atty are one piece.
Looking at it, You would think there would be some intake holes or something drilled into it?
O ya, now im getting good flow!!!

 

[Madison Ave]

I too found the draw alot easier on the ego without the cone. Not sure if that is the problem you may be having, but, give it a try.

 

[908Tracy]

+1 on the advice of no cone=easier draw. Give it a shot.

 

[Papa Lazarou]

Not sure which model I have, but the cone and atty are one piece.

Sounds like you have one of the eGo mega cone atomizers like this JOYE eGo Mega(Cone) Atomizer in 10 colors(Type A) [Joye eGo] - $9.50 : Healthcabin Electronic Cigarettes - Wholesale and Retail