I want input so no offense at all. I am vaping at around 9 wattage not voltage and for some reason i thought they were different. My voltage i guess is still high though at 3.8
What did i just inhale?
- Thread starter Breezy Dawn
- Start date
- th_trl_thread_readers 0
- Status
Great deal. I come off a bit sharp at times but it is not intended.
On the ProTank 3...
a few tips/tricks I have learned through my use. Even though it does not say to do this, prime the wick when you change up your coil. Especially if you are using thick juices (70/30 or higher). You would do this by screwing the coil into the base (I also suggest grabbing a adjustable airflow base for the ProTank, its around 5-7 bucks at most), with the coil set into the base, pull the chimney off by applying side pressure in one direction. drip a few drops onto the wicking in the middle and wait a few moments and put one or two more drops on. Reseat the chimney and make sure the rubber is touching the wick.
After you fill your tank and let it sit for a bit (~5 min or so) block or obstruct the air holes if you can and take a few puffs without hitting the power button. keep doing this as long as you see bubbles coming up from the wick. With thick juice I would suggest a primer puff before taking a drag from the ProTank, just to make sure there is enough juice on the wick to keep it from dry burning.
On the ProTank 3...
a few tips/tricks I have learned through my use. Even though it does not say to do this, prime the wick when you change up your coil. Especially if you are using thick juices (70/30 or higher). You would do this by screwing the coil into the base (I also suggest grabbing a adjustable airflow base for the ProTank, its around 5-7 bucks at most), with the coil set into the base, pull the chimney off by applying side pressure in one direction. drip a few drops onto the wicking in the middle and wait a few moments and put one or two more drops on. Reseat the chimney and make sure the rubber is touching the wick.
After you fill your tank and let it sit for a bit (~5 min or so) block or obstruct the air holes if you can and take a few puffs without hitting the power button. keep doing this as long as you see bubbles coming up from the wick. With thick juice I would suggest a primer puff before taking a drag from the ProTank, just to make sure there is enough juice on the wick to keep it from dry burning.
Here are my little guys,its a love hate thing so far! Ive been playing with the wattage since last post and i seem to settle in at 8.5,least with this juice and ohms read 1.9. Ive also done more reading and looking for charts since i last posted but most everything shows volts not watts. I think i will try to prime that way,may be fun to take apart!
I wouldn't get too hung up on the watts and volts. I run a 18650 mech @ 0.3 and it works great. That's 4.2v with a full charge and with that build I used the stream engine calculator to figure that runs around 40-45 watts- with a full charge. If u have the rba deck try playing with some different builds.
Sent from my SM-G860P using Tapatalk
Sent from my SM-G860P using Tapatalk
- Status
Similar threads
- Locked
