what RBA fit a twisted 30g dual coil?

[xxxtn12]

Hello everyone,
I have a igo-w and i can only do single coil build with twisted 30g.
Dual coil doesnt fit in the holes.

What rba can fit a dual coild build with twisted 30g?

Thanks,
Christian

 

[Chevren]

I can fit dual twisted 26 in my igo w it just takes a little adjusting and some plier work lol, 30 guage twisted fits in with plenty of spare room I actually have a dual twisted 30g coil on mine right now.

Sent from my SCH-I545 using Tapatalk

 

[SLIPPY_EEL]

a Trident would work, as you have open slit's coming down from the top of the pins instead of holes through the side

Im not familier with the igo-w but maybe you could look into drilling out the holes on yours a little bigger, if you do please make sure you dont have your fingers anywhere near the the drill bit, always use something else to hold in that area, it doesnt take much for a drill bit to slip into your finger

 

[treehead]

Hello everyone,
I have a igo-w and i can only do single coil build with twisted 30g.
Dual coil doesnt fit in the holes.

What rba can fit a dual coild build with twisted 30g?

Thanks,
Christian

The prometheus by grand vapor kicks the pants off my russian 91%, better vapor than most of my RDA'S, and exceelent flavor too, they both have the screw-down style if your ok with that, but the promethus has a fairly wide slit in the positive post that can easily fit 22ga without any effort, it would heartily chuckle at twisted 30ga, I've fit twisted 24 gauge in'er before (but it had to be unravled and layed on top of eachother only in the positive post, the negative posts can probably handle twisted 22ga easily (not that most would want to), I thread it between the edge of the chamber and the negative post, then I can screw it down hands free, it holds the wire for you! The slit in the positive post is really easy too, I had a little trouble with massive 20ga wire one time, but it's built so well I decided to shove it in there with a screwdriver, and it actually bent and molded the kanthal! It's so tough that it actually pinched the kanthal slightly flatter, talk about a good connection.

Hope this helped!

 

[treehead]

a Trident would work, as you have open slit's coming down from the top of the pins instead of holes through the side

Im not familier with the igo-w but maybe you could look into drilling out the holes on yours a little bigger, if you do please make sure you dont have your fingers anywhere near the the drill bit, always use something else to hold in that area, it doesnt take much for a drill bit to slip into your finger

The trident RDA is an awesome one, but careful with twisted wire because my (clone anyway) Trident couldn't fit twisted 28ga in the slits, I tried to force it in stupidly and when I tightened the cheap clone down it snapped the outer part of the slit, now I use it for test coils and twist the wire around the remaining slit creatively .

 

[vampyrex13]

I have dual triple twisted 30 gauge in my IGO-W, so I don't know why you can't fit your wires in there. I have mine twisted very tight so it looks almost like rope.