I've got an AGA-T2 and an AGI. I don't care what type of rba it is. I'd like something easy to build on. Also something that juices wont degrade.
What RBA tank should I get next?
- Thread starter withravenoushunger
- Start date
- th_trl_thread_readers 0
- Status
Go with an RSST. The tank material on the newest version is more resilient to cracking.
you mentioned you had the agi, do you use it mostly in tank mode? how is it working with the spring center post? did you find that the coil is more compact because of the distance it gives you between the base deck and top of positive post?
I've only used it briefly in tank mode. I haven't seen any problems with the spring but I've heard it can be problematic. I'm not sure if it varies from spring to spring. I'm hoping someone will find a solution for the spring. I think it would work better if they just put a post there instead.
RSST is really nice for a clone, the insulated wick hole and tank makes setup a breeze.
I rarely get hot spots on the rsst after wraping.
I rarely get hot spots on the rsst after wraping.
you know I just fixed it. I made a quick coil and checked the resistance of the device in dripper mode, it read 1Ω, I then attached the tank and checked the same coil in genny mode and it was 1.4Ω. so I pulled out the spring and attached a bit of tube from a cart, I rechecked it and got it to be 1Ω. I like using 28g wire and it just doesn't look like it gives you a lot of room for the coil, I think I will try to find a few small washers to add to the pp.
- Status
Similar threads
