What wattage do you vape at?
- Thread starter Nirk
- Start date
- th_trl_thread_readers 0
- Status
Im running 8 on my SVD with my Trophy v2. I'll see what I can do when my iClear 30B comes in
I'm usually around 8 watts, give or take .5 watts depending on topper and juice.
6.5 watts on my PT and bottom coils, 8 watts on my genesis style RBA (take a second to really get rolling [once the coil is warm...oooh what a vape!])
on my iTaste VV V3 with EVOD and ARO heads - 9-9.5W for most of my tobaccos, 7-8W for everything else.
This is not going to be the answer you are looking for, but, the one that doesn't taste burnt to you.
I rarely run my PT2M over 8, 8.5. But my KayFun and carto's, 11, 11.5, 12....
It comes down to the juice too, fruity juices seem to burn at lower watts to me..
I'm at 7-8 with my kangers, on the itastes I usually go a little lower, it really depends on the juice Im using but its never a drastic change...
That's what I do, crank it up, then dial it down according to your own tastes. What tastes burnt to me, may taste delicious to you...
8w on most attys but on my genesis style with ss mesh I go up to 10w, I think it works better with higher watts on genesis style.
Vaping while using Tapatalk
Vaping while using Tapatalk
7-8 on all my juices but one using PT and Evods. I mixed a DIY Sugar Cookie from FW and can't go over about 6 with it.
I'm usually at around 8.5 watts for almost everything. I find I can go a bit higher, but some juices start to burn a bit on the toppers I have or carto tanks.
15w at 1.3ohms when I'm at home, and usually around 8-10 when I'm out and about on my regulated
I like the upper 6 watt range. Maybe it's because I use vivi novas and ego batteries. Or maybe it's just my preference. It works well with my Hangsen or Dekang tobacco flavors.
I do my own coils, 5 wraps of AWG32 on 2mm Ekowool gives me 2.6 ohm, volts at 4.2, for 6.78 watts. The vape is warm, but not hot, and the taste really comes through well.
Raising watts from that point starts taking the experience downhill for me. Going higher makes the vape increasingly hot, and the taste starts going away. But maybe if I had a Provari, or some super duper mod, I'd change my mind.
I do my own coils, 5 wraps of AWG32 on 2mm Ekowool gives me 2.6 ohm, volts at 4.2, for 6.78 watts. The vape is warm, but not hot, and the taste really comes through well.
Raising watts from that point starts taking the experience downhill for me. Going higher makes the vape increasingly hot, and the taste starts going away. But maybe if I had a Provari, or some super duper mod, I'd change my mind.
- Status
Similar threads
