What watts to run cloupor dan 30 at

Status
Not open for further replies.

Cullin Kin

Ultra Member
ECF Veteran
Verified Member
Jun 28, 2014
2,746
3,449
The 3Oh!3, Colorado
www.youtube.com
No one can tell you what you'll like, just try it for yourself. Something around 15 watts sounds about right for it.

This. That's why you have 30 Watts ti play with. However, tanks like the Fogger and kayfun can only wick so fast so there will be a cutoff. On my KFL+ V2 built at 1.5Ω I have my Cana set at 17.2W. Anything above that an I can taste that the wick is struggling to keep up.

The Fogger does seem like it's a little more capable with the bigger building deck. Who knows.
 

EDO

Ultra Member
ECF Veteran
Verified Member
Feb 15, 2009
1,538
502
Watts and ohms mean nothing unless you know what gauge of wire is going to be used. A 1.5 ohm dual coil made from 32g wire is nothing like a 1.5 ohm dual coil made from 28g wire. The latter would be a very unusual build and would require way more than 30 watts to heat up the coils enough to produce any vapor.
 

Because I like to run at the highest power I can without burning, and that's where I start to notice burning with different resistances.

EDIT: I also missed the fact that he's using a Rebuildable. With rebuildables I crank my dna to 30 watts no matter what. Usually in tanks with pre made coils, they use much smaller gauge wire that heats up super fast and burns much easier than what you would build in a RTA or RDA.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread