Whats going on here?

[Naza]

So I got a l rider mini (red) last week and so far hate it . First problem, I guess no really a bigy but the connection is not straight anything I attach to it is tilted to the side when I stand up the tube. Second problem is very inconsistent and often poor vapor and throught hit. I am using a couple of the Xtreme visions and some ce3's. I get more flavor th and vapor using my ego-t pass through than I do with the lt. I checked volts with my multi meter, the ego is putting out 3.37 and getting better gapes than the lt at 4 volts when I try the lt at 3.3 I get pretty much nothing. And anything over 4 volts is burned. I am using 70/30 pg/vg juice peppermint and menthols. What the heck am I doing wrong?

Sent from my iPad using Tapatalk HD

 

[Naza]

Forgot to add I have checked the ohms on all my carto's and they range 2.8-3.1

 

[unloaded]

Sounds like the CE2's aren't wicking enough to keep up with the coil. Have you done any tweaking of them to get them to wick better?

 

[MASTER0FDAMPF]

If you can, send it in. There seem to be some batches of the color ones that just suck

 

[Naza]

Sounds like the CE2's aren't wicking enough to keep up with the coil. Have you done any tweaking of them to get them to wick better?

I've notched the slots in the cup were the wicks go to the coil and remover some of the rubber material from the cup that would be around the coil and fluffed the wicks up a bit. They are working great on my ego battery just not my lt

If you can, send it in. There seem to be some batches of the color ones that just suck

For that I look to where I bought it from?

 

[Retriever]

I would hope you would be able to send it in for a replacement. Just the tilting of the connection would be enough for me to send it back. The money you sent them was not defective, why should you settle for less?

 

[Naza]

Not sure how this will come out but heres a quick picture of it

 

[Mainspring]

Not sure how this will come out but heres a quick picture of it

that is not acceptable. send it in. that looks really bad.

the first one I had was a little crooked. wasn't so bad when I put just a carto on it but put a tank? forget about it. leaning tower of pisa... hated it... 1 problem of many with that one...

far as the vapor problem... if it's working fine on the ego, it might just be that the juice does not like the higher current.

also, if you have a volt meter, check the voltage reading on the LT to the meter and see if it's consistent.

my first and the second replacement I had was a bit off. shouldn't matter if it's just .1 or .2 but just to make sure.


edit: and with that my 500th post.

 

[ChrispyCritter]

Look at the connector itself to see if it looks crooked..when my "LT" was new the center pin stuck up a bit much and a lot of the cartomizers didn't screw in all the way..after some use it "broke in" or otherwise the rubber in the connector squished in and once the cartos went in all the way they were nice and strait. Unless the connector looks crooked itself which can happen this might be whats going on with yours..also if it's not going in all the way you should be able to see the gap between the cartomizer connection and the device...

 

[MASTER0FDAMPF]

It does seem to plague teh red mini more than other units. My red one had a slightly tilted connector, but that was remedied by screwing a tank down tight on it (a metal vision tank).