What's your trick for a one punch carto in a tank?

[New2vaps]

I have a 19mm STANDARD IBtanked carto tank. I am using a 1 punched Boge carto. Because the tank is small by the time the tank is about 1/2 empty when I tilt it to vape the punched hole is not getting any ejuice. This means I have to fill the tank.

Some times when I place the carto in the tank, the punched hole is facing the firing button on my provari which means the ejuice is getting tilted towards the hole and I can vape on a lower filled tank.

So the question is, is there a trick to make sure the punched hole is facing the firing button?

Thank you

 

[Tbev]

Hahaha I have the same setup the answer I have found is to push the button with your finger not your thumb. (spin 180deg) I have used one and two hole cartos and I definitely believe the single larger hole works better.

Sent from my Transformer TF101 using Tapatalk

 

[New2vaps]

Thanks Tbev, actually I received a reply from another post and might as well update. Specially if someone new might come across this.

In a nut shell, you can't modify the carto it's self to face any way you want. It's the luck of the draw where the punch lands.

1- Like you said, twist the mod and press with your finger rather than your thumb

2- Use an adapter or an air flow controller and that will solve the problem. The threading on those will almost always put the carto hole on the opposite side of where it was.

3- Don't buy pre punched cartos. Punch the carto your self. Place it first on the mod, mark it where it aligns with the firing button and then punch it.