RX GEN3 is a continuation of the RX line, in comparison with its predecessor, the mode has greatly diminished in size, despite the fact that power is also supplied from 3 18650 batteries, and the maximum output power is 300W.
The fashion was developed by JayBo, so his name is decorated with the button "Fire".
Below, under the buttons "+" and "-" there is a USB port for charging and flashing the mod.
In the upper part of the case there is a standard 510 connector. It is located close enough to the edge, this limits the maximum size of the installed tank to 25 mm. Everything that has large dimensions will stick out of the frame. By the way, the connector is not pressed, but is part of the case. Also on top we see engraving with the name of the model.
Two drippers are supplied. Let's see how they look on the tank.
The tank has an outer diameter of 25 mm, its capacity is 2ml. In the lower part of the tank there is a ring for adjusting the blowing. I liked the ring, it rotates easily and smoothly. It also has a built-in limiter that does not allow it to rotate around its axis.
At the base of the 510th connector and engraving with the brand logo and model name.
In the tank, a filling system with a sliding lid is used. Moreover, the lid not only slides forward and back, but snaps into place when closing. Inside the evaporator WM02 c with a resistance of 0.15 Ω, designed for operation in the power range from 30 to 70 W, is installed. The second evaporator in the kit is designated WM03 and has a resistance of 0.2 ohms. The evaporator is designed for operation in the following power range: 40-130 W.
The fashion was developed by JayBo, so his name is decorated with the button "Fire".
Below, under the buttons "+" and "-" there is a USB port for charging and flashing the mod.
In the upper part of the case there is a standard 510 connector. It is located close enough to the edge, this limits the maximum size of the installed tank to 25 mm. Everything that has large dimensions will stick out of the frame. By the way, the connector is not pressed, but is part of the case. Also on top we see engraving with the name of the model.
Two drippers are supplied. Let's see how they look on the tank.
The tank has an outer diameter of 25 mm, its capacity is 2ml. In the lower part of the tank there is a ring for adjusting the blowing. I liked the ring, it rotates easily and smoothly. It also has a built-in limiter that does not allow it to rotate around its axis.
At the base of the 510th connector and engraving with the brand logo and model name.
In the tank, a filling system with a sliding lid is used. Moreover, the lid not only slides forward and back, but snaps into place when closing. Inside the evaporator WM02 c with a resistance of 0.15 Ω, designed for operation in the power range from 30 to 70 W, is installed. The second evaporator in the kit is designated WM03 and has a resistance of 0.2 ohms. The evaporator is designed for operation in the following power range: 40-130 W.
