Z-ATTY Pro did I break it?

[Slider_Z33]

I have a Z-Atty Pro and I built my own coil and was very very happy with it. I attached it to my Natural mod and I think I over tightened it and the black delrin shaft moves up and down now? I put it on my pro Vari and it read OP so I took the cap off and pushed it down and it worked. So basically the pin on the bottom moves up and down and So does the centre shaft? They move easily!! did I break it and is it fixable???? Here are picks of what I mean. Help please??

Sent from my iPad using Tapatalk HD

 

[Jeremy Evans]

Nope you didnt break it, just make sure the delrin is completely dry and push it back down and then dont tighten it so much when you screw it on. Mine did this a few times randomly. Definitely not broken though

 

[NayrTrawe]

This happened to my ZAU when I first got it. The delrin piece is actually glued into the shaft and, in some cases, it will come loose. When I contacted the supplier they confirmed that I could just glue it back in myself without affecting the warranty - that said, my advice would be to contact the company you bought it from before trying to fix it just to be safe.

 

[Slider_Z33]

Ok thanks guys I appreciate it. I bought it from Provape so I will contact them directly. I was so worried I wrecked it. Still way to new to this rba stuff. Thanks you


Sent from my iPad using Tapatalk HD