Zeus X Mesh problem

[simplesid242]

I got 2, built one with included ni mesh, the other with ss 200 mesh. Using both with temp control. On the ni build dry hits after a couple second puff. On the ss build, it flooded within a couple minutes of filling, I used it anyway and after I dumped the flooded juice, it vapes great, but now it's about due for a new wick. I think. I ran about 200ml thru, vape is still decent, but it is losing some flavor. Also both are built with rayon. From Sally's the Graham 44060 Just trying to figure out what I'm doing wrong to correct it.

Sent from my SM-N975U using Tapatalk

 

[Shawn Hoefer]

I got 2, built one with included ni mesh, the other with ss 200 mesh. Using both with temp control. On the ni build dry hits after a couple second puff. On the ss build, it flooded within a couple minutes of filling, I used it anyway and after I dumped the flooded juice, it vapes great, but now it's about due for a new wick. I think. I ran about 200ml thru, vape is still decent, but it is losing some flavor. Also both are built with rayon. From Sally's the Graham 44060 Just trying to figure out what I'm doing wrong to correct it.

Sent from my SM-N975U using Tapatalk

The included ni mesh is not nickel... it's nichrome80, and not suited for TC. Run that in wattage.

Sent from my SM-N960U using Tapatalk

 

[simplesid242]

Oops... did not even realize that.... makes sense now then. Thank you.

Sent from my SM-N975U using Tapatalk

 

[Superuser187]

It's known on the net in videos and stuff that the Zeus x rta there is a problem with the chamber and it's not press fitted all the way...u just give it a light hit or press it very hard and it presses in place...maybe that's why one has flooding problem...just saying in case u haven't seen

The one u say had dry hits I guess u need adjust your wicking..