Hi everyone. I'm wondering if anyone out there has the same issue....?
I actually hope a representative of Vandy Vape sees this...and hopefully gives an explanation.
I'm at my wits end here. The problem is specifically with the 0.6 ohm coil....I use it in the Jackaroo pod. I've bought a few packs some months ago, and almost half of them don't wick properly. Right from installation (I do drop and soak properly before use) some coils just don't stay wet. After a few pulls it gives off a burnt taste.
The 0.3ohm coils don't do that though.
My thinking is the cotton isn't tightly contained enough between the two casings inside the coil.
If it was a cotton issue, the 0.3 would do that to.
Hopefully I just bought a bad batch...although i'm very reluctant to buy more of these 0.6 coils.
Can anyone shine any light one this plz.
Thanks.
I actually hope a representative of Vandy Vape sees this...and hopefully gives an explanation.
I'm at my wits end here. The problem is specifically with the 0.6 ohm coil....I use it in the Jackaroo pod. I've bought a few packs some months ago, and almost half of them don't wick properly. Right from installation (I do drop and soak properly before use) some coils just don't stay wet. After a few pulls it gives off a burnt taste.
The 0.3ohm coils don't do that though.
My thinking is the cotton isn't tightly contained enough between the two casings inside the coil.
If it was a cotton issue, the 0.3 would do that to.
Hopefully I just bought a bad batch...although i'm very reluctant to buy more of these 0.6 coils.
Can anyone shine any light one this plz.
Thanks.
